Q-Logic 8C/16 Uživatelský manuál stáhnout pdf (Strana 148)

A – Command Line Interface

Set Config Command

A-34 59022-06 A

zoning

Initiates an editing session in which to change switch zoning attributes. The

system displays each parameter one line at a time and prompts you for a value.

For each parameter, enter a new value or press the Enter key to accept the

current value shown in brackets.

Falling Trigger The event count below which a falling

threshold alarm is logged. The switch will

not generate another falling threshold

alarm for that event until the count

exceeds the rising threshold and

descends again below the falling

threshold.

Sample Window The period of time in seconds in which to

count events.

Table A-12. Set Config Zoning Parameters

Parameter Description

FC-SW-2 AutoSave Available only when the FC-SW-2

Compliant parameter is True, this

parameter enables (True) or disables

(False) the saving of changes to active

zone set in the switch’s permanent

memory. Refer to ”FC-SW-2 Compliant” on

page A-32. The default is True.

Default Enables (All) or disables (None)

communication among the switch’s ports/

devices and the fabric in the absence of an

active zone set. The default is All.

Table A-11. Set Config Threshold Parameters (Continued)

Parameter Description

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 221 222

Žádné komentáře

Q-Logic 8C/16 Uživatelský manuál Strana 148