Q-Logic FIRMWARE VERSION 7.4 Uživatelský manuál stáhnout pdf (Strana 17)

3 – Event Messages

Fault Events

59060-05 A 3-3

HW_BAD_SEATING

Meaning: Blade is improperly seated.

HW_MP_ACCESS_CPU0

Meaning: The maintenance panel SPROM data accessed through CPU0 is

either inaccessible or invalid.

HW_MP_ACCESS_CPU1

Meaning: The maintenance panel SPROM data accessed through CPU1 is

either inaccessible or invalid.

HW_MP_DATA_MISMATCH

Meaning: The maintenance panel SPROMs accessed through CPU0 and

CPU1 are not identical.

HW_POWERUP_FAIL

Meaning: Blade never established initial communications.

HW_SENSOR_FAULT

Meaning: Hardware temperature/voltage sensors are not functional.

HW_UNSUPPORTED_BLADE

Meaning: Installed blade is unknown or not supported.

SENSOR_FAULT

Meaning: Power Supply blade reports an internal fault.

temp_sensor_TEMP

Meaning: The temperature sensor reading is out of range; it is too high.

temp_sensor can be BOARD_0, BOARD, BOARD_1, DS1780_0,

DS1780, DS1780_1, MAX1617_0, MAX1617, ASIC_0, ASIC,

MAX1617_1, ASIC_1, or MEZZ_BOARD.

voltage_sensor_HIGH

Meaning: The voltage_sensor voltage supply is out of range; it is too high.

voltage_sensor can be 1.55V, 2.5V, 1.5V, ASIC_1.8V, 1.25V, 1.8V,

3.3V, CPU_1.8V, 5V, 12V, ASIC_0_1.5V, or ASIC_1_1.5V.

voltage_sensor_LOW

Meaning: The voltage_sensor voltage supply is out of range; it is too low.

1.55V, 2.5V, 1.5V, ASIC_1.8V, 1.25V, 1.8V, 3.3V, CPU_1.8V, 5V,

12V, ASIC_0_1.5V, or ASIC_1_1.5V.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 83 84

Žádné komentáře

Q-Logic FIRMWARE VERSION 7.4 Uživatelský manuál Strana 17